Awarded
17/229 - Threaded Ball Valves for use with Natural Gas
Descriptions
A Single Supplier Framework Agreement for the manufacturing and/or supply of Threaded Ball Valves for use with natural gas. Applicant shall note that if they are appointed to the Framework Agreement, they will be required to supply either directly to the Gas Networks Ireland or at the Contracting Entity's sole discretion, to the Contracting Entity’s Agents or other authorised contractors on the same terms to the terms of the Framework Agreement. All Applicants to note; in order to pre-qualify they must be able to demonstrate that they can fulfil the requirements for Gas Networks Ireland for the specific lot/lots being applied for. It is envisaged that the scope of products and services of the initial Contract to be drawn-down under the Framework Agreement will be, but are not limited to the items listed in the table below; 1/2" Ball Valve threaded female female BSPT3/4" Ball Valve threaded female female BSPT1" Ball Valve threaded female female BSPT1& 1/2" Ball Valve threaded female female BSPT2" Ball Valve threaded female female BSPTLocking devices for ball valvesAngle Bodied threaded Ball Valve ¾” BSPTAngle Bodied threaded Ball Valve 1" BSPT - The requirements for the manufacture and/or supply of threaded ball valves under this Framework Agreement will include arrangements for delivery to GNI Stores located in Cork and Dublin or specified locations by the Contracting Entity’s Agents or other authorised contractors. Applicants should note that from time to time over the term of the Single-Party Framework Agreement, the Contracting Entity, at its sole discretion but without altering the overall nature of the Single-Party Framework Agreement, may require to modify the scope of the contract to reflect changes in threaded ball valve requirements, ancillary equipment and fitting requirements required for the operation and maintenance of GNI’s gas network and resulting from technology-driven innovation developments. Refer to PQQ document.
Timeline
Published Date :
Deadline :
Contract Start :
Contract End :
Tender Regions
CPV Codes
44163160 - Distribution pipes and accessories
44163000 - Pipes and fittings
42131140 - Pressure-reducing, control, check or safety valves
42131260 - Ball valves
42130000 - Taps, cocks, valves and similar appliances
42131100 - Valves defined by function
42131142 - Control valves
65210000 - Gas distribution
44161100 - Gas pipelines
44163150 - Low-pressure pipes
44161110 - Gas-distribution network
44161600 - Low-pressure pipeline
39340000 - Gas network equipment
42131147 - Safety valves
42131000 - Taps, cocks and valves
Keywords
gas network equipment
gas pipeline fittings
gas distribution hardware
IPv gas valves
pressure regulators
pipeline components
tap fitting
cock valve
faucet unit
plumbing valve
shut-off valve
mixer tap
ball valve
gate valve
globe valve
needle valve
tap appliance
faucet fitting
cartridge valve
compression valve
flow control valve
control valves
pressure valves
safety valves
sluice valves
radiator valves
temperature regulators
function-specific valves
industrial valve
pressure reducing valve
control valve
check valve
safety valve
relief valve
pressure regulator
backflow preventer
safety relief valve
valve assembly
proportional valve
regulating valve
process control valve
automatic control valve
pneumatic control valve
pressure safety valve
excess pressure valve
overpressure valve
spring-loaded safety valve
boiler safety valve
safety pop valve
fluid safety valve
safety shut-off valve
pressure protection valve
floating ball valve
trunnion ball
quarter-turn valve
industrial ball valve
stainless ball valve
gas ball valve
electric ball actuator
high-pressure ball valve
flow shut-off ball
natural gas line
methane carrier
fuel transmission pipe
gas utility conduit
energy supply pipeline
municipal gas grid
regional supply system
gas mains network
urban fuel routing
utility distribution loop
low‑pressure pipeline
utility distribution conduit
residential pipeline
low-stress fluid transport pipe
standard pipeline
pipe assemblies
plumbing fittings
mechanical pipe components
threaded pipe units
industrial pipe systems
low-pressure pipes
standard-pressure tubing
domestic fluid lines
utility conduit
non-pressurized pipes
distribution pipes
pipe network components
mainline tubing
service pipe assemblies
pipe infrastructure parts
natural gas delivery
gas supply network
pipeline gas
residential gas
utility gas distribution
gas flow regulation
public gas service
LPG distribution
commercial gas systems
energy pipeline service
Tender Lot Details
2 Tender Lots
Workflows
Status :
Procedure :
Suitable for SME :
Nationwide :
Assign to :
Tender Progress :
Details
Notice Type :
Tender Identifier :
Tenderbase ID :
Low Value :
High Value :
Buyer Information
Name :
Procurement contact
Name :
Phone :
Email :
Possible Competitors
1 Possible Competitors
