FM20099 - Build of 6 x Control Panels

Descriptions

The final date and time for the submission of bids is Thursday 25th June 2020 at 11:00. DO NOT apply directly to the buyer. All tender information MUST be submitted through the Delta eSourcing Portal. Brief Description of Requirement: The Deep Underground Neutrino Experiment (DUNE Project) is an international collaboration focussed on Neutrino science and Proton decay studies. The experiment consists of a Neutrino Source based at Fermi National Accelerator Laboratory in Batavia, Illinois; and two Neutrino detectors, one near field (local to the source), and one far field detector based at Sanford Deep Underground Research Facility in Lead, South Dakota. The Neutrino's travel 1300km through the earth, from the source to the far field detector located 1.5KM below ground level, in a converted mine shaft. Anode Plane Assemblies (APA) are the building blocks to construct the large far field detector. An APA is a 6M x 2.3M rectangular frame which is wound with a fine Copper beryllium wire mesh and will be used to capture activity caused by passing Neutrino's. Electronics on the frame convert this activity into an electrical signal for measurement and analysis by Physicists. Further information can be found at: https://www.dunescience.org/ The requirement is for the vendor to build 6 electrical control panels which will operate 6 winding machines used to produce wound APA frames for the DUNE project. 4 of the control panels produced will control winders based at Daresbury Laboratory (DL), whilst the remaining 2 control panels will be shipped to the US to run 2 winders installed at the Physical Sciences laboratory (PSL) in Madison, Wisconsin, US. The winders will produce several hundred APA frames over the coming years. Please ensure you review all attached information to ensure a full understanding of this requirement. All attachments can be found with the Document Uploads tab within the Delta eSourcing Portal. This contract will be awarded based on the evaluation criteria set out in the ITQ document. How to apply: UK Shared Business Services Ltd (UK SBS) will be using the Delta eSourcing Portal for this procurement. To register on the Delta eSourcing portal please use the link https://uksbs.delta-esourcing.com and follow the instructions to register. If you are already registered on the Delta eSourcing Portal and wish to participate in this procurement, please use the link: https://uksbs.delta-esourcing.com and the follow the instructions to 'Login'. Once you are logged into the system you will be able to link yourself into this procurement using the Access Code: A4G52Q93J5. Please disregard any content in this notice that requests your organisation "to apply directly to the buyer" as this unfortunately a system generated error, that is outside of the Contracting Authorities control.