Office for Product Safety and Standards- Construction Products Testing

Descriptions

The Department for Levelling Up, Housing & Communities ("the customer") has a potential requirement for the provision of "Construction Products Testing". The Secretary of State for the Department for Business and Trade ("DBT") is the contracting authority responsible for meeting this anticipated requirement on behalf of the Customer. DBT intends to publish the Contract Notice week commencing 15th May 2023. The full specification shall be provided with the tender documents, but it is expected to incorporate the testing of a variety of construction products to assess their fire safety, structural and thermal efficiency classifications. The testing requirements will be broken down into four lots each covering a variety of construction products and test procedures. These lots are as follows: Lot 1 - Insulation and Cladding - Testing will be used to verify the reaction to fire classifications and thermal efficiency of a range of products used both internally and externally as wall linings, pipe insulation, roofing and flooring. This will be done using the following standards and the relevant normative references contained within: BS EN 13501-1:2018 BS EN 13501-5:2016 BS EN 12667:2001 Lot 2 - Electrical Cables - Testing will be used to verify the reaction to fire classifications of a range of products including power, control and communication cables. This will be done using the following standards and the relevant normative references contained within: BS EN 13501-6:2018 Lot 3 - Plywood & Wood Based Materials - Testing will be used to verify the reaction to fire classifications and the structural/mechanical properties of a range of plywood and wood-based products for both internal and external use. This will be done using the following standards and the relevant normative references contained within: BS EN 13501-1:2018 BS EN 13986:2004+A1:2015 Lot 4 - Smoke Control Dampers and Fire Dampers - Testing will be used to verify the resistance to fire classifications and the structural/mechanical properties of a range of smoke control and fire damper products. This will be done using the following standards and the relevant normative references contained within: BS EN 13501-4:2016 BS EN 13501-3+A1:2009 It is anticipated the framework shall be for a period of 12 months.. The requirement has an estimated total value of £810,000 (exc-VAT). Each lot has the following estimated value: Lot 1- £200,000 Lot 2- £150,000 Lot 3- £160,000 Lot 4- £300,000 Each lot will operate on a call-off basis. DBT reserves the right to not spend the full framework amount if it is not required.