Open Closing in a 1 month
Installation of CVIM Generator Back Up Power
Request tender documents
Save your time. You just request and we will send you the available documents.
Request for bid service
Save your time. You just request and we will arrange tender related all available documents to bid writers for the best possible quote.
Descriptions
The purpose of this project is to increase the Institute’s electrical supply resilience (both continuity of science and vaccine production, plus to reduce potential financial loss), reduce waste and safeguard the vaccine batch production via resilient power supply to the building utilising either mains power or generated power in the event of site wide power failure. This will be achieved by a combination of the following two factors: • New 510kVA stand-alone emergency back-up generator. • UPS resilience on critical equipment to ensure power is bridged whilst generator runs up to speed and then takes the load of building. Contract Scope The contract is for a single supplier to provide Design and Build of a permanent automatic emergency power back up in case of power failure and to ensure conditions inside the CVIM building remain intact and vaccine production is not interrupted as per the User Requirement Specification (URS) for The Pirbright Institute (Pirbright), Ash Road, Pirbright, Surrey, GU24 0NF. See Appendix E - Contract Specification. PROJECT SCOPE AND OBJECTIVES The Principal objective is to provide permanent automatic emergency power back up in case of power failure and to ensure conditions inside the CVIM building remain intact and vaccine production is not interrupted. The contract is for a single supplier to provide comprehensive installation of a stand-alone 500kVA generator and Automatic Transfer Switch to supply our new CVIM building that derives its primary power supply from T8 substation. Works to include all wiring and connections (ACB already in place in T8 substation), testing and commissioning , ability to send up to 5 alarms to the BACS control room, concrete base (Approx 6mx 3m and 0.5m deep) lightning protection to match existing Jenner Building generator and pipe in pipe connection to existing diesel fuel tank. The following Work packages are to provide a one stop shop for the total installation described here in and are subject to a full tender process, advertised on Find a Tender: The contract is for a single supplier to act as the Principal Contractor and complete all works as follows: • Delivery of a Stage 4 electrical design with client nominated designer and Project Manager • Supply and Installation of 1 x 510kVA 3 phase power generator. • Generator to be fitted with day tank for diesel fuel • New 3m by 6m concrete pad next to Jenner’s generator. • Means of automatic power disruption detection equipment to auto start generator and switch to generator supply in the event of amins failure. • Facilitate installation & commissioning of generator and auto switching. • Added pipe in pipe to existing diesel fuel tank with controls for low level shut off. • Controls and cabling between new generator and Automatic Transfer Switch (ATS). • Provision to add a plug in generator into the ATS. • Test feature of key switches to run Off and On line for testing without affecting normal supply to building. • Commissioning and handover including Project Information Folder (PIF) is provided to the client Project Manager Work Package: CVIM Generator and ATS installation
Timeline
Published Date :
Deadline :
Contract Start :
Contract End :
Tender Regions
CPV Codes
31122000 - Generator units
45317000 - Other electrical installation work
45310000 - Electrical installation work
31120000 - Generators
31127000 - Emergency generator
44114250 - Concrete slabs
31100000 - Electric motors, generators and transformers
51111200 - Installation services of generators
51111000 - Installation services of electric motors, generators and transformers
Keywords
AC generator
engine generator
floor slabs
UPS generator
DC generator
precast slabs
transformers
building wiring
electric motor
concrete slabs
ceiling slabs
rotary converter
emergency genset
backup generator
generators
cable routing
power module
generator unit
generator set
pavement slabs
transformer grounding
portable generator
fuel line connection
generator set placement
standby power unit
circuit installation
internal power grid
transformer oil filling
load bank testing
auxiliary generator
grounding strap fitting
lighting and power setup
control panel wiring
transfer switch install
motor vibration test
standby generator
motor belt tensioning
generator coupling
power transformer
electrical installation
motor base alignment
industrial generator
exhaust system install
disaster recovery unit
transformer positioning
motor starter wiring
electrical infrastructure
electrical connection works
generator commissioning start-up
generator fuel tank hookup
battery charger connection
electrical network installation
electrical systems fitting
generator load bank hookup
specialist electrical fitting
other electrical installation work
additional electrical service integration
electromechanical devices
miscellaneous electrical systems installation
generator ventilation setup
Tender Lot Details & Award Criteria
1 Tender Lots
Workflows
Status :
Procedure :
Suitable for SME :
Nationwide :
Assign to :
Tender Progress :
Details
Notice Type :
Tender Identifier :
Tenderbase ID :
Low Value :
High Value :
Buyer Information
Name :
