Bombora Wave Power Europe Limited tenders

An independent final evaluation of the mWave Demonstration ERDF project, in line with Welsh European Funding Office requirements for the final evaluation of the project. The contractor will:- Review the mWave Demonstration ERDF Project against the la ....

Marine Operations Services are required for the installation, operations and maintenance of the Bombora mWave device in Pembrokeshire. The following services are required:1. Completion of the design/planning needed for the marine works2. Execution of ....

The scope of work consists of the planning and mobilising a survey vessel and completing pre-installation hydrographic and geophysical surveys at the mWave East Pickard Bay deployment site.The primary objective of the surveys is to locate an area wit ....

The PTO attachment mechanism consists of a combination of steel welded plates and machined Stainless steel linkage pins. The contractor will be expected to procure material and fabricate the mechanism, and deliver the unit complete.

The mWave device is a 900ton steel structure which is approximately 75m Long, 15m wide & 6m high. The structure is required to be loaded into the water from its assembly site in the port of Milford haven, Pembroke Dock. We are looking for a full cont ....

Diving services are required to support the operations and maintenance of the mWave wave energy device. In providing these services the Contractor will work alongside the Bombora operations team and their suppliers.The organisation providing the serv ....

Bombora Wave Power would like to hire marine equipment in order to complete the marine operations to install mWave and carry out ongoing maintenance over it's 12 month testing period.The following items are required for the installation and are antic ....

Require the supply of a GNSS compass and radio telemetry system with the following requirements:•GPS heading accuracy =/- 0.5°•Wireless transmit to installation vessel 100-200m•The system needs to be self-contained, with enough battery capacit ....

Bombora wishes to appoint a contractor for the manufacturing and supply of four stitched fabric harnesses for restraint of the expansion of inflatable rubber membranes.The restraint harness is a large fabrication of various polymer lifting sling mate ....

Fabrication of a the Cell module grabber tool of profiled plate into a welded assembly mass of tool is aprox. 1500 kgsFabrication of two handed Power take off module grabber tool components primarily profiled plate into a welded assembly the total ma ....